PLC Control, HMI Operation, Small Occupation Area, Gap Cutting Machine

PLC Control, HMI Operation, Small Occupation Area, Gap Cutting Machine

PLC Handle, HMI Operation, Tiny Profession Spot, Gap Reducing Machine

Operate And Characteristic:
CQT-500 Hole chopping device CZPT servo motors, double synchronization, the dragging precision can be +/-.1mm%, max. feeding width is 520mm, valid width is 500mm, it is hole reducing, in this situation, can keep away from waste substance. Machine is only or minimize straight traces.

Scope of Software:
For lengthy strips dobule facet adhesive tapes, it can stay away from squander material, no require to rewind the wastage. When forming.

CZPT Info: 

Design CQT-500
Max Feeding Width (mm) five hundred
Primary Engineer Electricity (kw) .seventy five
Cutting Speed (cuts/min) one hundred thirty
Dimension (m) L1.4*W1.four*H1.3
Fat (t) .five
Cutting Precision (mm) ± .10
Voltage 220v 50hz
Complete electricity (kw) three.5

Ahead of reducing, it is ongoing tape, then we take away authentic liiner at the bottom shaft. 

And unwind a new liner, and lower the tape on to new liner, for the closing product, between each and every two tapes, there is a gap. This sort of hole can keep away from tape stick to each other once again. 

CZPTized equipment with top rewind shafts. 
Some consumers use this machine to die reduce the finger elevate tape. 
The top shafts are for rewind the trim wastage. 

This die is employed for make finger elevate and trim. 

Our CNC Workshop, all the mechanical areas are made by ourselves. 

Get from a single consumer. And this is not the initial time they bought our machines. 

We are the firm, who has our personal creating group, Most crucial issue is all our folks problem about the qulity of the equipment. 
Steady slicing force, hassle-free for functioning, trustworthy to all the customers. 
If machien isn’t appropriate for customers’ using, we will tell them the truth. 

All the machines we offered out, should be in a position to help client to generate earnings for the customer. 
In any other case, we would like not promote the device. 

But if customers’ products belong to our business, we will try our very best to persuade customer think about about our equipment. 
Just due to the fact machines are actually with good high quality and better construction. 
We hope all clients have excellent good quality device to use. 

PLC Control, HMI Operation, Small Occupation Area, Gap Cutting Machine